Yamaha XV19SW 2006 Service Manual page 81

1. Fuel tank breather hose
2. Fuel sender (fuel tank)
3. Fuel tank
4. Fuel hose (fuel tank to fuel hose joint)
5. Fuel return hose (fuel return pipe to sub-fuel tank)
6. Air vent hose (fuel hose joint to fuel tank)
7. Fuel hose joint
8. Fuel outlet hose
9. Fuel pump
10. Sub-fuel tank
11. Fuel hose (fuel hose joint to fuel pump)
12. Fuel return pipe
13. Fuel return hose (pressure regulator to fuel return
pipe)
14. Pressure regulator
15. Rollover valve 1
16. Rollover valve 2
17. Cylinder-#2 left spark plug lead
18. Rollover valve hose 1
19. Rollover valve hose 2
20. Starter motor lead
21. Fuel tank breather/overflow hose
22. Rollover valve hose 4
23. Rollover valve hose 3
24. Air vent hose (fuel pump to fuel hose joint)
25. Fuel pump coupler
26. Canister purge hose (for California only)
27. Canister (for California only)
28. Canister breather hose (for California only)
A. Align the blue paint mark on the fuel hose (fuel
hose joint to fuel tank) with the round indentation on
the bend in the fuel hose joint.
B. Face the fastener of the clamp downward, making
sure that the projections on the clamp are
positioned as shown in the illustration.
C. Align the white paint mark on the end of the fuel
return hose (fuel return pipe to sub-fuel tank) with
the white paint mark on the fuel return pipe.
D. White paint mark
E. Align the ends of the hose clamp with the white
paint mark on the fuel return hose.
F. Align the paint marks on the hoses with the hose
joint as shown in the illustration.
G. Fasten the fuel tank breather/overflow hose to the
throttle cable guide with the holder.
H. Align the paint mark on the hose with the hose joint
as shown in the illustration.
I. Fasten the fuel tank breather/overflow hose and
starter motor lead with the holder.
J. To the fuel injector
K. Align the yellow paint mark on the air vent hose
(fuel hose joint to fuel tank) with the round
indentation on the bend in the fuel hose joint.
L. Face the fastener of the clamp to the left.
M. Face the ends of the hose clamp forward.
N. Install the air vent hose (fuel pump to fuel hose
joint) with its white paint mark facing upward.
O. Face the ends of the hose clamp upward.
P. Face the fastener of the clamp upward, making
sure that the projections on the clamp are
positioned as shown in the illustration.
Q. Install the fuel hose (fuel tank to fuel hose joint)
with its white paint mark facing downward.
R. To the pressure regulator
S. Install the air vent hose (fuel hose joint to fuel tank)
with its white paint mark facing downward.
T. For California only
U. To the fuel tank
V. To the intake manifold assembly
W. Fasten the canister purge hose and fuel tank
breather/overflow hose with the holder, making sure
to align the paint mark on the breather/overflow
hose with the holder.
X. Fasten the canister purge hose and throttle cable
guide with the holder.
2-56
CABLE ROUTING