Yamaha XV19SW 2006 Service Manual page 71

1. Clutch hose
2. Right handlebar switch lead
3. Main switch
4. Left handlebar switch lead
5. Front brake hose
6. Throttle cable (decelerator cable)
7. Throttle cable (accelerator cable)
8. Horn 1 lead
9. Horn 1
10. Rear brake light switch
11. Rear brake light switch lead
A. Cross the left and right handlebar switch leads.
Either lead can be routed on top.
B. 70 mm (2.76 in)
– °
C. 5 25
– °
D. 10 30
E. Fasten the rear brake light switch lead with the
plastic locking tie. Face the end of the plastic
locking tie inward, and then cut off the excess end
of the tie.
F. Make sure that there is no slack in the rear brake
light switch lead in the area shown in the illustration.
G. Fasten the rear brake light switch lead with the
plastic locking tie. Face the end of the plastic
locking tie downward, and then cut off the excess
end of the tie.
2-46
CABLE ROUTING