Advertisement
REMOVING THE PLOW
To remove the snowplow from your truck, park on
a solid level surface with the blade straight across
the truck. Lower the plow to the ground and leave
the controller in the "float' mode.
Lower Plow, Leave Controller In "Float" DWG. NO. 4163
NOTE: The plow control box must be in the "float"
mode to manually retract the lift cylinder rod. If the
cylinder rod cannot be retracted with power on and
the controller in float, loosen the packing nut on
the lift cylinder up to 1 1/2 turns to reduce friction.
Retracting the lift cylinder before removing the
plow from the truck will orient the prong receivers
correctly for reattaching the plow later. Failure to
retract the lift cylinder rod will allow the lift frame
to fall forward, possibly causing personal injury or
damage to plow components.
With the plow lowered to the ground and the con-
troller in the "float" mode, push down on the upper
lift links to full retract the lift cylinder rod.
Retract Cylinder With Upper Lift Links DWG. NO. 6000A
Rotate the stop plate up to contact the spacer
bushing on the lift cylinder bolt.
Rotate Stop Plate
Gently push back on the headlight bracket to tilt
the frame back as far as possible, then release the
bracket to allow the weight of the lift frame to lock
the stop plate in place.
Push Lift Frame Back
Swing the latch handle open until the sliders are
fully removed from the attachment prongs.
Swing Handle To Remove Sliders
Operating Procedures 7
DWG. NO. 6004A
DWG. NO. 6005C
DWG. NO. 6722A
Advertisement
