Advertisement
10 Controller Configuration
NOTE: The 2 pin power cable and 16 pin plow har-
ness must be connected, and the vehicle's ignition
switch must be switched on in order to test the
functions of the headlights and power unit.
1.
Ensure the black and white 12 pin connec-
tor from the cab harness is attached to the
controller.
2.
Use the plow selection switch to select
whether you have a V-Plow or a Straight
Blade.
NOTE: As supplied from the factory, the snow-
plow controller raises the plow when the joystick
is pulled backward and lowers the plow when
the joystick is pushed forward. If you wish to re-
vers this follow steps 3 through 5. If not, skip to
step 6.
Model
9585, 9595
9863, 9963, 9710 Compression V
2754, 2804, 2854 Steel Straight
8804, 8904
6814, 6914
7814, 7914
703, 753
CONTROLLER CONFIGURATION
DWG. NO. 8006
Plow Type
Postion
Torsion V
Up
Up
Down
C
Down
Scoop
Down
Poly Straight
Down
Mid Size Straight
Down
3.
Pry the face plate of the controller by insert-
ing a small screwdriver along the side of the
plate of the plate at location 1 in drawing
5855A. Flip the plate over, then reinstall by
gently sliding the 4 tabs into the slots in the
controller top.
4.
To reverse the joystick switch, gently pull on
the edges of the small circuit board at the
base of the joystick switch to remove the
switch from the 5 pins on the main circuit
board.
5. Rotate the switch 90 degrees then gently
push the switch back onto the 5 pins.
6.
Insert the main circuit board into the case
top ensuring the joystick is properly seated
and the harness strain relief is inside the
case.
7.
Assemble the case with the 4 screws.
8.
Test the controller on the snow plow to ver-
ify that raise and lower functions are what
the operator desires.
DWG. NO. 5855A
Advertisement
