Display Settings; How To Ride - Populo CURVE User Manual

DISPLAY SETTINGS

Press and hold + and - buttons for about 2 seconds to enter the display setting screen, after your have
done the setting, the display will be back to normal mode after about 2 seconds.
Adjust display brightness: Press the power button to enter P01 Screen, the use + and – buttons to adjust
the brightness of the display' s backlight.
Switch measurement Unit: Press the power button to enter P02 screen, then use + and – buttons to set
the display to the desired measurement type between imperial (miles, mph) and metric (km, km/h).

HOW TO RIDE

Warning!
You should wear an approved bicycle helmet every time you ride a bicycle, regardless of the legal
requirement to do so. Additionally, some jurisdictions require helmet use when riding Class III eBike, you
should comply with local law when riding your bicycle.
Always Inspect gears, examine brakes and check tire pressure before riding. Proper tire inflation can
reduce flats and improve performance, including travel distance per charge.
This Populo Curve Electric Bicycle is designed with 3 di erent riding modes of Pure Electric,
Power-assisted as well as Pedal mode.
Start your eBike by pressing and holding the power button on the display for 2 seconds, or ride it with
your feet directly. Before you ride with pure electric mode, you need to set power-assisted level to be at
least level 1 ( power-assisted level 0 will not activated to throttle)
Move forward by pressing the throttle down.
Switch between 6 gears by rotating shifter on the right handle bar.
To stop, release the throttle, then squeeze the front and rear brakes to slow the front and rear wheel
down.
SPEED: This icon shows a current riding speed as measured in mph or km/h.
Assist: This number shows the assist level (1-5)
11