Advertisement
Technician Setup Menu
Operation of the FAN & SYSTEM button when connected
to WIFI and running a programmable schedule from the
app:
When the set at temperature is changed while an app schedule is
running, the thermostat will enter a temporary hold, and the Fan and
System buttons change to RUN and HOLD for 5 seconds. If you wish to
enter PERMANENT HOLD press the HOLD button at this time.
If you don't press the HOLD button within the 5 seconds, it will remain in
temporary hold for 4 hours.
When connected to WIFI you may also have the ability to turn
programming ON or OFF by pressing and holding the FAN button for
3 seconds, while the FAN BOX appears.
WIFI Setup
These WIFI Technician steps/
options are intended for
information and trouble-shooting.
They are not used for installation
or initial setup.
Follow these steps to enter the
WIFI-technical information menu.
1. Press and hold the + and - buttons
together for 3 seconds.
2. Press WIFI button at lower right.
3. Top of display will show:
"WIFI NOTOK" if NOT connected
to WIFI. "WIFI OK" if connected to
WIFI.
4. IF NEXT button is pressed, top of
display will show:
The firmware and software
versions that are installed on the
thermostat. You can scroll through
them with the + and - buttons.
5. IF NEXT button is pressed again,
top of display will show:
The SSID # of the thermostat. if
NEXT is pressed again, you will
return to step 4.
The only normal function you
would use this step for would be to
RESET WIFI provisioning. For
example: If you replaced your
home WIFI router and need to
connect via a different network.
Follow these steps to enter the
WIFI-technical information menu.
1. Go through steps 1 and 2 from the
WIFI menu at left.
2. Press and hold the TECH button at
lower left for 3 seconds.
3. Top of display will show:
"RESET WIFI"
4. Press the YES button at lower left.
After a 5 second countdown, the
thermostat will reset.
Or press NO to exit
Advertisement
