Table of Contents
Advertisement
Figure 66
1. Deck-lift arm
2. Chain
6.
Ensure that there is tension on all 4 chains
(Figure
66).
7.
Tighten the 4 adjustment bolts
8.
Ensure that the blocks fit snugly under the deck
skirt and that all bolts are tight.
9.
Verify that the deck is level by checking the
side-to-side level and front-to-rear blade slope;
repeat the deck leveling procedure if necessary.
g297515
3. Hook
4. Adjustment bolt
(Figure
66).
Removing the Mower Deck
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
3.
Lower the mower to the 76 mm (3 inches)
height-of-cut position.
4.
Remove the mower belt from the engine pulley;
refer to
Replacing the Mower Belt (page
5.
Remove the hairpin cotter and washer securing
the link pin to the frame and deck, and remove
the link bar
(Figure
1. Link pin
2. Washer
6.
Lift up the mower deck to relieve tension from
the mower deck.
7.
Remove the chains from the hooks on the
deck-lift arms
45
67).
Figure 67
3. Hairpin cotter
(Figure
68).
39).
g297517
Advertisement
Table of Contents
