Exiting Programming Mode; Disabling/Enabling Time Periods - Honeywell ST9100A User Manual

PrOGrAmmING YOUr ST9100A

exiting Programming mode:

To exit programming mode, move the slider to the rUN position. This can be done at
any time during the programming process, and any changes made and confirmed
with the button will have been saved.
Note: If the unit is left in programming mode for more than 10 minutes without the
slider being moved or any buttons pressed, the message 'MOVE SLIDER' will be
displayed. Press a button to finish programming, or move the slider to the rUN
position.
Disabling / enabling Time Periods
To disable any of the time periods ON 1 to OFF 1 or ON 2 to OFF 2, simply set the
ON time and its paired OFF time to the same time, and the programme will just
ignore them.
To re-enable the time period, simply set the two ON and OFF times to be different.
9