Exiting Zone 1 Programming Mode; Modifying The Zone 2 Programme; Exiting Zone 2 Programming Mode; Disabling/Enabling Time Periods - Honeywell ST9500C User Manual

Exiting ZONE 1 Programming Mode:

To exit ZONE 1 programming mode, move the slider to the RUN position. This can
be done at any time during the programming process, and any changes made and
confirmed with the
Note: If the unit is left in ZONE 1 Programming mode for more than 10 minutes without the
slider being moved or any buttons pressed, the message 'MOVE SLIDER' will be displayed.
Press a button to finish programming, or move the slider to the RUN position.

Modifying the Zone 2 Programme

The zone 2 programme has three pairs of ON/OFF switching times per day. Each
time can be set between 3.00 am and 2.50 am (on the next day) to allow you to
programme zone 2 to stay on past midnight, if required.
a. Move the slide switch to the ZONE 2 position. 'SET ZONE 2' will show briefly to
verify this action.
DAY/TIME
ZONE 1
ZONE 2
RUN
b. Now follow the same procedure to set the times as described in 'Modifying the
Zone 1 Programme' (page 7) steps b. to i.

Exiting ZONE 2 Programming Mode:

To exit ZONE 2 programming mode, move the slider to the RUN position. This can
be done at any time during the programming process, and any changes made and
confirmed with the
Note: If the unit is left in ZONE 2 Programming mode for more than 10 minutes without
the slider being moved or any buttons pressed, the message 'MOVE SLIDER' will be
displayed. Press a button to finish programming, or move the slider to the RUN position.
Disabling / Enabling Time Periods
To disable any of the time periods ON 1 to OFF 1, ON 2 to OFF 2, or ON  to OFF ,
simply set the ON time and its paired OFF time to the same time, and the programme
will just ignore them.
To re-enable the time period, simply set the two ON and OFF times to be different.
button will have been saved.
button will have been saved.
PROGRAMMING YOUR ST9500C
ZONE 1
(for Zone 1 and/or Zone 2)
ZONE 2
9