Operating Your Heater - HOMCOM 820-144V01BN Owner's Manual

PREPARATION
Place the heater on a firm, level surface and plug into a 120V~ 60Hz power outlet.
And turn on the power switch in the rear of the unit. Insert 2 AAA batteries into the remote
control before using (Batteries Not Included)

OPERATING YOUR HEATER

Once the Electric fireplace has been properly assembled and connected to a electrical
outlet.
1.Start and select working mode
or
Power
or
HEATER
High Low Eco Turn off
2. Setting room temperature
or
UP
...
Turn the heater on by pressing the Power button on the
control panel or by pressing the Power button on the
supplied remote control.
Once power is off, heating element will stop working at
first. Fan will prolong working for 90 second to emit
plenty of heat inside. Then shut OFF automatically.
Select a heat setting.
Press the HEATER button to toggle between the three
heat settings.
The power of the high-level mode is 1400W, the power of
the low-level mode is 700W, and the ECO mode is the
economic mode. The high-level heating or low-level
heating is automatically adjusted according to the
ambient temperature power. If you want to turn off the
heating separately, just press the heating button instead
of the power button. When the individual heating is off, "-
-" will be displayed for 5 seconds, and then the ambient
temperature will be displayed.
Adjust the thermostat by pressing the arrows on the
control panel or remote control.
DOWN
Set temperature indication varies from 59 F to 95 F. Once
you have chosen the desired temperature, the heater will
remain on until the room temperature increases to the
temperature on the digital display. The heater will cycle
on and off to maintain the desired room temperature.
6
0 0