Section 4 - Operating Instructions; Tiger Eye Instrument Identification - Scag Power Equipment TurfTiger II STTII-52V-25CH-LP-EFI Operator's Manual

R
CAUTION
Do not attempt to operate this mower unless you
have read this manual. Learn the location and
purpose of all controls and instruments before
you operate this mower.
Before operating the mower, familiarize yourself with all
mower and engine controls. Knowing the location, function
and operation of these controls is important for safe and
efficient operation of the mower.
This machine is equipped with the Tiger Eye Advanced
Monitoring System. With the key in the on position, before
starting the engine, the lights for the Seat Indicator, PTO
Indicator, Neutral Indicator and Park Brake Indicator
should be illuminated. This indicates there is an operator
in the seat, the PTO is off, steering levers are in neutral,
and the parking brake is applied. When all the lights are
illuminated, the key can be turned to the start position
and the mower can be started. See Section 4.3 Safety
Interlock System. If any of these indicator lights are not
illuminated, the engine will be prevented from starting. If
additional information or service is needed, contact your
Scag Power Equipment Dealer.
4.1 TIGER EYE INSTRUMENT
IDENTIFICATION
1. Service Air Filter Indicator (Figure 4-1). Optional
Accessory. Indicates the condition of the engine air
filter. Icon will display when it is time to change the
air filter.
2. Glow Plug Indicator (Figure 4-1). Used on Diesel
Powered Units Only. Indicator turns on when the
key switch is turned to the ON position. Glow plug
timer will cycle on for approximately 5 seconds as
glow plugs preheat. At the end of the cycle, the
indicator will turn off. Glow plugs must be preheated
before starting the engine.
3. Oil Pressure Indicator (Figure 4-1). Used on
Diesel Powered Units Only. Indicates engine oil
pressure. Reference the engine operator's manual
for further information.
OPERATING INSTRUCTIONS
4. Service Engine Indicator (Figure 4-1). Indicates
the maintenance reminder for the engine oil change.
Has preset maintenance reminder and will start
flashing scheduled maintenance 2 hours before
preset time and continue flashing until 2 hours after.
Automatically resets.
5. Voltmeter Indicator (Figure 4-1). Indicates the
condition of the charging system. When the engine
is running, in normal operating conditions, the bar
graph should be in the 12 to 14 volt range.
6. Seat Indicator (Figure 4-1). Light will illuminate
when the operator is in the seat engaging the seat
switch.
7. PTO Indicator (Figure 4-1). Light will illuminate
when the PTO (mower deck) switch is in the OFF
position.
8. Hourmeter Indicator (Figure 4-1). Indicates the
number of hours the engine has been operated.
It only operates when the engine is running. Will
start flashing with the Service Engine Indicator
at scheduled maintenance 2 hours before preset
time and continue flashing until 2 hours after.
Automatically resets.
9. Neutral Indicator (Figure 4-1). Light will illuminate
when the steering control levers are in the neutral
lock position.
10. Park Brake Indicator (Figure 4-1). Light will
illuminate when the park brake is in the engaged
(ON) position.
11. Water Temperature Indicator (Figure 4-1). Used
on Liquid Cooled Models Only. Indicates the
operating temperature of the engine. If the engine
temperature exceeds the maximum preset value, the
indicator will flash and the Park Brake, PTO, Seat
and Neutral indicator lights will flash in an alternating
pattern.
12. Fuse Holders (Figure 4-2). Two 20-amp fuses
and one 5-amp fuse protect the mower's electrical
system. To replace fuses, pull fuse out of the socket
and install a new fuse.
14
Section 4