Table of Contents
Advertisement
30
Hawk 2LP Family Installation Guide, Rev. A
________________________________________________
Drive installation
This section describes the physical mounting of the drive in the
host cabinet and the logical installation as a system member,
which is called drive setup.
Disc drive mounting
Do not touch the connector pins or any PCB components
without observing static-discharge precautions. Always handle
the drive by the frame only.
The drive may be mounted in any orientation.
• Mount to host system chassis using four 6-32 UNC screws.
Three mounting holes are in each side and four in the bottom
of the drive. See Figure 6. The maximum length that the
screws should extend into the side chassis mounting holes
is 0.15 inch (3.81 mm), and 0.20 inch (5.1 mm) into bottom
holes, measured from the outer surface of the chassis. The
minimum thread engagement for all mounting screws is .12
inch (3.0 mm). Tighten the screws evenly to a maximum
torque of 6 in-lb (.675 NM). Do not over tighten or force when
screw does not seem to screw in easily (threads not correctly
engaged).
Advertisement
Table of Contents
