Table of Contents
Advertisement
Hawk 2LP Family Installation Guide, Rev. A
17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Initial set-up information
For the initial setup connect the cables or plug into a mounted
connector (if applicable), set the drive ID on the bus and enable
or disable the I/O line terminator IC ("N" models). These
procedures are described in paragraphs following. Note
whether drive model number ends in N or ND.
SCSI interface cable connection
Models Hawk 2LP family are SCSI interface drives. System
connection is via a 50 pin SCSI connector. Pin 1 is noted in
Figure 2. Some cables have a contrasting color stripe on one
edge to indicate pin 1. Strain relief is recommended at the
cable in drives using cables. Do not block system cooling air
flow in routing of cables.
Advertisement
Table of Contents
