Kohler K-1168 Installation Manual page 19

Test Run the Bath (cont.)
Rotate the outer ring to the chromatherapy icon, then press "OK". The chromatherapy lights will
automatically and continuously cycle through the eight colors; white, violet, indigo blue, aqua blue,
green, yellow, orange and red. One cycle through all eight colors takes approximately 1 minute.
Press "OK" while the chromatherapy mode is active to turn off the chromatherapy lights.
Rotate the outer ring to the chromatherapy specific color icon, then press "OK". Use the up or down
arrows to reach the desired color.
Press "OK" again to turn off the chromatherapy lights.
Operate the Automatic Purge Cycle
NOTE: The automatic purge cycle occurs after the bath is drained. It operates at low speed for about 2
minutes to remove any residual water from the air channels.
If required, fill the bath to a level at least 2" (5.1 cm) above the top of the highest airjet.
Drain the bath.
When the water level drops below the level sensor probes, verify that the blower starts at low
speed.
After about 2 minutes, verify that the blower motor stops.
Operate the Manual Purge Cycle
With the bath drained, rotate the outer ring to the purge cycle icon.
Press the "OK" icon.
Observe that the blower starts in the purge cycle. Residual water will blow out from the air
channels.
After the blower has operated for about 2 minutes, observe that the blower stops.
Place the protective drop cloth over the bath.
Turn off the power to the bath.
Kohler Co. 19 1035472-2-J