Step 5: Interactive Setup; Step 6: Place Batteries In The Remote Control; Step 7: Plug In And Turn On The System - RCA DXD406RD User Manual

Setup and Connections

Step 5: Interactive Setup

If you need to run the interactive setup, select Options from the
Main menu, then select Interactive Setup.
If you just want to check your dish pointing coordinates, or run the
signal strength meter, select Dish Pointing from the Main menu.
Step 6: Place Batteries in the
Remote Control
Follow these steps whenever you need to install or change the
batteries in your digital satellite receiver's remote.
1. Remove the cover from the battery compartment.
2. Insert batteries into the battery compartment, matching
the + and – end of each battery.
3. Replace the cover.
STEP 7: Plug in and Turn on the
System
Plug the end into the wall outlet. Be sure to insert the plug
completely.
To turn on the system, press the SAT button on the remote or on the
ON•STBY button on the front panel. If your TV brand is RCA, GE, or
P S , press the TV button on the remote to turn on the TV. If your
RO CAN
TV brand is not RCA, GE, or P
Remote, for details on how to use the remote to control your TV.
NOTE: Your receiver is not completely turned off as long as it is
receiving power from the wall outlet. To shut the receiver off
completely, unplug it from the wall.
10
S , see the next section, Using the
RO CAN