Place Batteries In The Remote Control; Plug In And Turn On The Receiver; Wait For The Receiver To Download Advanced Program Guide™ Data - RCA DRD435RH User Manual

Connections & Setup
Note:
The message "Searching for Satellite Signal" might
appear briefly at the bottom of your screen when
you turn on your satellite receiver for the first time.
This is normal.
If this message stays on the screen for more than
one minute, check your receiver's on-screen signal
meter to make sure your antenna is receiving the
strongest possible satellite signal. See "Signal
Meter" on page 36 for more information.
Note
The Satellite Data Acquisition screen will also
appear when:
• your unit loses power (either from a power
outage or being unplugged)
• your unit loses the satellite signal for an
extended period of time.
8

Place Batteries in the Remote Control

Follow these steps whenever you need to install or change the batteries in your digital satellite
receiver's remote control.
Note: When replacing old batteries, you may need to reprogram the remote control to operate other devices.
Avoid pressing any of the remote control buttons while you're replacing old batteries. If you press a remote control
button while replacing batteries, you will need to reprogram the remote control to operate other devices.
1. Remove the cover from the battery compartment.
2. Insert batteries in the battery compartment, matching
the + and – end of each battery.
3. Replace the cover.

Plug in and Turn on the Receiver

Plug the end of the power cord into the wall outlet. Be sure to insert the plug completely.
To turn on the satellite receiver, press the DIRECTV button on the remote control or the POWER
button on the front panel. If your TV brand is RCA, GE, or Proscan, press the TV button on the remote
control to turn on the TV. If your TV brand is not RCA, GE, or Proscan, see page 11 in the next section,
Using the Remote Control, for details on programming the satellite receiver's remote control to
operate your TV.
Wait for the Receiver to Download ADVANCED PROGRAM GUIDE™ Data
The first time you connect a receiver to a satellite antenna you've already installed and pointed
correctly, the receiver starts to gather information for the program guide.
After you turn on your receiver and tune your TV to the correct video input channel, a progress bar
appears indicating that the receiver is gathering this program guide information.
To prevent any damage to your TV screen, the progress bar disappears after 2 minutes (the screen
goes blank).
Note: When the progress bar reaches 100%, there might be a delay before you actually see video on the screen.
If the screen stays blank for more than 2 to 3 minutes, you need to reset the receiver.
To reset the receiver:
1. Unplug the satellite receiver's power cord from the power outlet.
2. Wait a few seconds, and plug the power cord back into the outlet.
3. Turn on the receiver and wait for it to download program guide information.
Chapter 1