Step 3: Place Batteries In The Remote Control; Step 4: Plug In And Turn On The Digital Satellite Receiver; Step 5: Connect The Vcr Controller - RCA Digital Satellite Receiver User Manual

Setup and Connections
Step 3: Place Batteries In the
Remote Control
Follow these steps whenever you need to install or change the batteries
in your digital satellite receiver's remote control.
1. Remove the cover from the battery compartment.
2. Insert batteries in the battery compartment, matching
the + and – end of each battery.
3. Replace the cover.
Step 4: Plug In and Turn On the
Digital Satellite Receiver
Plug the end of the power cord into the wall outlet. Be sure to insert the
plug completely.
To turn on the digital satellite receiver, press the DIRECTV button on the
remote control or the ON•OFF button on the front panel. If your TV
brand is RCA, GE, or PROSCAN, press the TV button on the remote to
turn on the TV. If your TV brand is not RCA, GE, or PROSCAN, see the
next section, "Using the Remote," for details on how to program the
remote to control your TV.

Step 5: Connect the VCR Controller

In order for you to use the One-Touch Record and Timer recording
features, you need to attach the VCR Controller to the back of the
digital satellite receiver.
1. Plug the VCR Controller into the VCR jack on the digital satellite
receiver.
2. Affix the other end to the remote control sensor on your VCR.
Back of Digital Satellite Receiver
RF REMOTE
RF REMOTE
OUT
*
DIGITAL
SATELLITE
SATELLITE AUDIO
DIGITAL AUDIO
IN IN OUTPUT
OUTPUT
Front of VCR
REMOTE SENSOR
*The digital audio output jack is only available on model DRD480RE.
14
R
R
IN
OUT
TO
TO FROM
TV TV ANT L
L
AUDIO VIDEO
AUDIO VIDEO
S-VIDEO
VCR
PHONE
LOW
JACK
SPEED
DATA
VCR
When replacing old batteries, note that
you may have to reprogram your remote
to control other devices.