Flex FX1671 Operator's Manual page 16

WARNING
product damage due to a short circuit, never
immerse your charger or battery pack in
fluid or allow a fluid to flow inside them.
Corrosive or conductive fluids, such as
seawater, certain industrial chemicals, and
bleach or bleach-containing products, etc. can
cause a short circuit.
VARIABLE-SPEED TRIGGER SWITCH
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned ON or
OFF by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
This Angle Drill must be used only with the battery packs and chargers listed below:
2.5Ah 3.5Ah
FX0111 FX0321
NOTE: For best performance, it is recommended to use higher Ah battery packs FX0331, FX0221,
FX0341 and FX0231.
NOTE: Please refer to the battery pack and charger manuals for detailed operating information.
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
(FIG. 12)
Battery Pack
5.0Ah 6Ah
FX0121 FX0331
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
parts.
Fig. 12
8.0Ah 10Ah 12Ah
FX0221 FX0341 FX0231
-16-
If any parts are damaged
or missing, do not operate
To prevent accidental
starting that could cause
Variable-speed
Trigger Switch
Charger
FLEX FLEX FLEX
FX0411 FX0421 FX0431
FLEX
FX0451