Binding; How To Bind - Spektrum Air Module System Manual

Binding

It's necessary to program the receiver to the specific module so that the receiver
will only recognize that module, ignoring signals from any other sources. If the
receiver is not bound to the module, the system will not operate. During binding
the servo's fail-safe positions are stored.
The following sequence shows the binding procedure for the AR9000, however, all
Spektrum aircraft receivers are bound in the same way.

How to Bind

The AR9000 receiver must be bound to the module before it will operate.
Binding is the process of teaching the receiver the specific code of the transmitter
so it will connect to that specific module. Once bound, the receiver will only
connect to that module.
14
All manuals and user guides at all-guides.com
1. With the system hooked up as shown, insert the bind plug in the
charge plug receptacle.
Note: When binding using a switch harness, a 3-wire switch harness must
be used such as SPM9530.
Note: To bind an aircraft with an electronic speed controller that powers
the receiver through the throttle channel (BEC), insert the bind plug into the
battery port and proceed to Step #2.
Spektrum Air Module