Table of Contents
Advertisement
Observe the notes mentioned following when wiring to the power supply
terminal board.
Precautions to be taken for power supply wiring.
Use a round crimp-style terminal for connection to the power supply terminal
board. In case it cannot be used due to unavoidable reasons, be sure to
observe the following instruction.
Place the round crimp-style terminals on the wires up to the covered part and
secure in place.
• Ground terminal installation
Use the following method when installing the round
crimp-style terminal.
CAUTION
When connecting the inter-unit wirings to the terminal board using a single core
wire, be sure to perform curling.
Problems with the work may cause heat and fires.
4) Pull the wire and make sure that it does not disconnect. Then fix the wire in place with a wire stop.
■English
Round crimp-style
terminal
Screw
Round crimp-
style terminal
Flat washer
Good
Stripping wire at terminal block
Stranded Wire
Screw
Flat washer
Round crimp-
style terminal
Wrong
10
Advertisement
Table of Contents
