Instructions For Periodic Maintenance - Makita DPC7331HD Instruction And Safety Manual

Instructions for periodic maintenance

To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be per-
formed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All such work must be
carried out by a MAKITA service centre.
General
Before each start
Every day
Every week
Every 3 months
Annually
Storage
8
Entire Power Cut
Cutting disc
Clutch
Protection hood
Cutting disc
V-belt
Protective hood
Combination switch,
Safety locking button,
Throttle lever
Tank cap
Air filter
Idle speed
Extreme dust
Starter housing
Starter cable
V-belt
Air filter insert
Spark plug
Muffler
Suction head
Fuel tank
Entire Power Cut
Entire Power Cut
Cutting disc
Fuel tank
Carburetor
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Inspect regularly for damage and wear.
Have inspected at a service center.
Clean, Check position (impact plate)
Inspect for damage and make sure the cutting wheel is
right for the job
Check V-belt tension
Adjust position
Functional check
Functional check
Functional check
Check for tightness and lekages
Clean (if necessary more frequently); pre-filter (foam)
maintenance as described above under Cleaning /
changing the air filter
Check (cutting disc must not turn on idle)
Clean filter insert (paper cartridge)
Clean to ensure proper air cooling
Check for damage
Check V-belt tension, inspect for damage and wear
Clean, replace after 100 operating hours
Check and replace if necessary
Check tightness of mounting, clean or replace
spark arrester screen if necessary
Replace
Clean
Check at an authorized service centre
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Remove and clean
Empty and clean
Run empty
Page
7
16
7
19
16
0-1
18
20-21
1

14, 19
20-21

1 / 6

1