Door Adjustments - U-Line CRE Series Quick Start Manual

QUICK START GUIDE

Door Adjustments

DOOR ALIGNMENT AND ADJUSTMENT
Align and adjust the door if it is not level or not sealing
properly. If the door is not sealed, the unit may not cool
properly, or excessive frost or condensation may form in
the interior.
NOTICE
Properly aligned, the door's gasket should be
firmly in contact with the cabinet all the way
around the door (no gaps). Carefully examine the
door's gasket to ensure that it is firmly in contact
with the cabinet. Also make sure the door gasket
is not pinched on the hinge side of the door.
CAUTION
!
Do not attempt to use the door to raise or pivot
your unit. This would put excessive stress on the
hinge system.
Alignment and Adjustment Procedure
1. On top and bottom sufaces of door, slightly loosen
hinge bracket screws.
2. Square and align door as necessary.
3. Tighten Torx head screws on hinge.
TO REVERSE THE DOOR
1. Hold door to keep it from falling.
2. Remove top hinge pin.
3. Remove door by tilting forward and lifting door off
bottom hinge.
4. Remove both hinges and replace 6 screws in hinge
holes.
5. Remove hinge pin from bottom hinge and install in
left-hand bottom hinge.
Install bottom hinge:
Install bottom hinge with 3 screws.
Install top hinge and door:
Hinge
Bracket
Install top hinge with 3 screws.
Install door:
1. Rotate door 180
2. Align door with hinge and install hinge pin.
Hinge Pin
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
Bracket
ADJUSTMENT)
6
Bottom Bottom
Right Hinge
Left Hinge
and set on bottom hinge.
o