Do you have a question about the BDXPC803 and is the answer not in the manual?
Questions and answers
William Brummett
June 2, 2025
After about two weeks the repeller would not detect or sense motion and so would not squirt. The phone number does not work and the web site is not responding.
1 comments:
Mr. Anderson
June 2, 2025
The Black & Decker BDXPC803 repeller may stop detecting motion and not squirt after two weeks due to the following reasons:
1. Low battery charge – If there has been cloudy or rainy weather, the solar-powered batteries may not have charged enough. Ensure the solar panel is facing the sun to recharge the batteries.
2. Sensor range adjustment set too low – Check and increase the range setting if needed.
3. Sensor not aimed correctly – Adjust the sensor to face the area where animals are entering.
4. Water pressure turned off – Confirm that water supply to the unit is on.
5. Loose or damaged connections – Inspect joints and washers for tightness and integrity. Replace damaged washers if necessary.
Page 1
For Deer, Rabbits, Groundhogs, Cats and other medium to large sized animals INSTRUCTION MANUAL CATALOG NUMBER: BDXPC803 Thank you for choosing BLACK + DECKER! PLEASE READ BEFORE RETURNING THIS PRODUCT FOR ANY REASON. If you have a question or experience a problem with your BLACK+DECKER purchase, go to www.
CONTENTS SAFETY INFORMATION Important Safety Instructions ...........................2 SET UP & USE How to Use ................................3 MAINTENANCE ....................................3 ASSEMBLY ....................................4 OPERATION ....................................5 SPRINKLER ADJUSTMENT ....................................6 BATTERY REPLACEMENT ....................................7 CUSTOMER SERVICE Troubleshooting ..............................8 Contact us ................................8 Limited Warranty ..............................9 PRODUCT REGISTRATION TO REGISTER YOUR PRODUCT VISIT: BLACKANDDECKERPESTCONTROL.COM Remember to record the model number of this device located on the base of this Model number...
PRODUCT SPECIFICATIONS BDXPC803 Model: Recommended water pressure: 7-116psi Recommended temperature range: 33-140F (1-60C) Power source for solar model: 2 x 1.2V AA NIMH rechargeable batteries Solar Panel: 4.5V DC, 0.5W SAFETY INFORMATION DEFINITIONS: Safety Alert Symbols and Words This instruction manual uses the following safety alert symbols and words to alert you to hazardous situations and your risk of personal injury or property damage.
Solar Panel to avoid damage. Solar Panel Pow- The Black and Decker er Cord BDXPC803 Deer Repeller is designed for simplicity. The technology behind this system uses Infrared Sensor sensors combined with advanced programming...
ASSEMBLY Fig. 1 Fig. 2 Fig. 3 Fig. 4 Optional Riser Tube Step Spike 1. Install included AA batteries as described in STEPS FOR BATTERY INSTAL- LATION located on page 7 of this manual. 2. Place solar panel component on top of sensor housing over threaded attachment as shown in Fig (1).
OPERATION Identify where you wish to place the BDXPC803 Repeller Device that will provide you with the best visibility to the animals you wish to deter WARNING: Product is intended for use with animals and should not be installed in a location that could startle a person.
SPRINKLER ADJUSTMENT Your BDXPC803 Deer Repeller comes with a precalibrated sprinkler head. Adjustments are possible to change the distance, range and pattern. • Distance: locate the distance adjustment dial at the top of the sprinkler head (Fig 9). In order to adjust setting, press down on lever as shown and rotate dial to desired setting.
Page 8
BATTERY CARE WARNING: • Battery acid leakage can cause personal injury and cause damage to the product and surrounding property. If battery leakage occurs, thoroughly wash any affected skin, making sure to keep battery acid away from eyes, ears, nose and mouth. Immediately wash any clothing or other surface that comes in contact with leaked battery acid.
CUSTOMER SERVICE WARNING: Do not try to adjust or repair the deer repeller yourself. Component parts shall be replaced with like components. Servicing shall be done by factory authorized service personnel to minimize the risk of possible harm due to incorrect parts or improper service. TROUBLESHOOTING Water is leaking from joints •...
LIMITED WARRANTY: REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE Any repair, replacement, or warranty service, REMEDY OF THE CUSTOMER; Umba and all questions about this product should be Group. SHALL NOT BE LIABLE FOR ANY directed to Umba Group at 1-888-338-6798 INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR Umba Group.
Need help?
Do you have a question about the BDXPC803 and is the answer not in the manual?
Questions and answers
After about two weeks the repeller would not detect or sense motion and so would not squirt. The phone number does not work and the web site is not responding.
The Black & Decker BDXPC803 repeller may stop detecting motion and not squirt after two weeks due to the following reasons:
1. Low battery charge – If there has been cloudy or rainy weather, the solar-powered batteries may not have charged enough. Ensure the solar panel is facing the sun to recharge the batteries.
2. Sensor range adjustment set too low – Check and increase the range setting if needed.
3. Sensor not aimed correctly – Adjust the sensor to face the area where animals are entering.
4. Water pressure turned off – Confirm that water supply to the unit is on.
5. Loose or damaged connections – Inspect joints and washers for tightness and integrity. Replace damaged washers if necessary.
This answer is automatically generated