Sony Glasstron Lite PLM-A35E Service Manual page 14

6. Power ON Procedure for Adjustment
(1) Connect an extension cable to the adjusting remote commander.
(2) After making sure that the HOLD switch on the adjusting remote commander is not turned on (not at left (NOR) position), supply 9
Vdc to the DC IN (J101).
(With the HOLD switch at HOLD position, the initial operation of the set does not finish, disabling the POWER switch function)
(3) Turn ON the POWER switch on the set. Confirm that a green LED lights up.
(4) Set the HOLD switch on the adjusting remote commander to the HOLD (right (ADJ)) position.
7. Adjustment Finishing Procedure
Page Address
Order
1. D 01 – 31
2. 2 00
3. 1 00
4. Set HOLD switch on adj. remote commander to NOR position.
8. Check screen skip mode setting
Order Page Address
1. 2 00
2. 2 2C
Resetting: Turn the POWER switch off.
9. Picture control standard setting (LCD and OPTICS blocks adjustments)
Order Page Address
1. 1 00
2. D 01
After LCD and OPTICS blocks adjustments
Page Address
Order
1. 1 00
2. D 01
Confidential
PLM-A35E (AEP)
Data
Check if adjusted data are written correctly to the given page and address.
00
Set data 00 to given page and address.
00
Data
01 Set data 01 to given page and address.
00 Set data 00 to given page and address.
Data
01 Set data 01 to given page and address.
41 Set data 41 to given page and address, and press PAUSE.
Data
01 Set data 01 to given page and address.
01 Set data 01 to given page and address, and press PAUSE.
Description
Description
Description
Description
3-4
Remarks
Page 2: Reset
Page D: Write protect
Remarks
Select RAM address page 1
No output check screen
Remarks
Page D: Cancel protect
Ope. – Brightness: Center
Remarks
Page D: Cancel protect
Ope. – Brightness: Reset center