Specifications - SSS Siedle ZTVP 850-0 W Product Information

English
Application
Table-top accessory for the
BVPC 850-... bus video panel for
conversion from a wall to a table-top
device.
Slip-proof table foot, connecting
cable with RJ45 plug, but without
telecom socket UAE 8(8).
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Modern furniture is coated with an
enormous variety of different lacquer
and plastic finishes. Constituents of
these materials can result in sof-
tening of the plastic feet in table-top
devices and so impair the surface of
the furniture. Please appreciate that
the manufacturer is unable to accept
any liability.
Note
For use only in dry indoor atmos-
pheres.
Scope of supply
Table-top accessory ZTVP 850-...
comprises:
• Slip-proof table foot in stainless
steel with threaded bolt to accom-
modate the device.
• 4 stainless steel nuts M3
• 2 tapping screws 2.5 x 8
• Cable guide with strain relief
device
6
• Connecting cable, 8-pole, 3 m
long with RJ45 plug
• This product information
Mounting
1 Open the device from the back by
pressing in the locking lever.
2 Place the base plate on the table-
top accessory and fasten using the
provided stainless steel nuts.
3 Break off the cable strain relief
device at the cable guide. Insert the
cable guide into the base plate and
close by exerting a slight pressure.
4 Insert the connecting cable from
the back of the table-top accessory
and use the cable strain relief device.
Installation
5 Connect the cores to the terminals
in accordance with the circuit dia-
gram. Do not remove the inserted
terminating resistor at the terminals
TaM and TbM. It is not possible to
loop through the video signal in the
in-house telephone with table-top
units.
The In-Home bus can only be relayed
via a bus distributor BVVU 650-...
to other bus telephones. If the bus
distributor is mounted under the
junction box, a deep version must
be used.
If the telecom socket has a shielding
terminal, this is not assigned.
• If switching and control functions
are executed, the contacts of the
telecom socket may have to be con-
figured for any occurring currents.
(See telecom socket data sheet)
• Unassigned cores must be insu-
lated and stored in the installation
chamber on the base plate.
6 Hook the housing into the base
plate from above and close by
exerting a slight pressure.
7 To remove the housing using a
flat blade screwdriver, push the
catch on the underside of the device
upwards and take the upper part of
the housing off the table foot with
base plate.

Specifications

Connecting cable: 8-core 3 m long
Ambient temperature:
+5 °C to +40 °C