In this case please verify sensor connections on terminal block.
If alarm persists even disconnecting completely sensor cable, please contact our service team.
4.4
Fuse fault
INFO/ALARM display will show «
Verify pool cover status and cabling before restarting the motor. In case of defect, change motor fuse
Motor fuse
4.5
Important Archimede force
INFO/ALARM display will show «
This alarm is risen just for information.
4.6
Excessive Archimede force
INFO/ALARM display will show «
This alarm is risen just for information.
4.7
Software defect
INFO/ALARM display will show «
In this case switch off completely the control board, wait 5 seconds and power it up again. If alarm persists contact
our service team
4.8
Electronic board defect
INFO/ALARM display will show «
This alarm informs about a major hardware problem on the board. Motor activation is inhibited. Please send back the
board for analysis and eventual repair.
4.9
Power feed defect
INFO/ALARM display will show «
In this case switch off completely the control board, wait 5 seconds and power it up again. If alarm persists contact
our service team.
Réf : 004057-02
» fix.
» blinking.
» fix.
» fix.
» blinking.
» fix.
User and installation manual
Page : 15/17