General Information - Unicum AN1244 User And Installation Manual

General information

To power-on the control box, press the red switch on the side and put on position « I »
The switch will light up and the board run its start-up sequence. During board
initialization procedure you'll see code «
few seconds.
Control box has been conceived and sized in order to work continuously up to 10
minutes maximum. Beyond this time try to let the board at rest for half an hour to allow
components cooling down.
Temperature working range is between 0°C and 50°C max.
Micro-switches programming
Contact held to open
1
Contact held to close
2
Safety loop disabled
3
Available
4
Available
5
Available
6
Réf : 004057-02
Control box configuration and programming
» blinking on INFO/ALARM display for a
= ON
= OFF
Micro-switches « SW1 »
OFF
Open with one pulse
Close with one pulse (Not compliant with NF P90-308
and forbidden in France)
Safety loop active
Available
Available
Available
User and installation manual
Power-on switch
ON
Page : 10/17