Powerhead And Cutter Removal - Shindaiwa HT230 Service Manual

5 Powerhead Removal
Section
Powerhead
Removal–HT230
10
IMPORTANT!
Service procedures for the HT230 DH230
powerhead are similar to those for the
T230 trimmer and are described in
Shindaiwa Grass Trimmers, Brushcutters
and Lawn Edgers Service Manual , Form
60506.
CAUTION!
Impact-type power tools can damage the
hedge trimmer drive assembly.
STEP 1. Disconnect the throttle cable end
from the throttle lever on the carburetor
(Figure 8).
STEP 2. Unplug the red ignition wire from the
ignition wire connector, and then tempo-
rarily remove the gearcase mounting bolt
to disconnect the black grounding wire
(Figure 8).
STEP 3. Remove the three 6 mm x 16 mm
gearcase mounting screws, and separate
the gearcase assembly from the
powerhead (Figure 9).
STEP 4. Remove the two 6mm x 35mm rear
handle bracket mounting screws, and lift
the rear handle assembly from the gear-
case (Figure 9).
Shindaiwa Inc. 1998
Air Cleaner
Throttle
(removed for
Lever
clarity)
Black
Ground Wire
Figure 8. Disconnecting the throttle cable
and ignition wiring
Powerhead
Gearcase
Assembly
Rear
Handle
Handle
Bracket
Mounting
Screw
Gearcase
Mounting
Screw
Handle Bracket
Mounting Screw
Figure 9. Removing the Gearcase Assembly
and Rear Handle Bracket
Cable End
Ignition
Wire
Connector
HT2306A
Red
Ignition
Wire
Gearcase
Mounting Bolt
HT2350
Rear
Handle
Bracket
Gearcase
Mounting
Mounting
Screw
Screw