Table of Contents
Advertisement
RCU800manual
3/8/00
2:03 PM
Programming For DVD
Most RCA, GE and ProScan DVD systems will not require programming. Check to see if
your DVD System responds to the remote before you begin programming.
1. Manually turn on the DVD System.
Find the three digit code for your DVD System in the
code list below.
2. Press and hold the CODE SEARCH button until
the INDICATOR LIGHT lights, then release the
CODE SEARCH button.
3. Press and release the DVD button
(The INDICATOR LIGHT will blink then remain lit).
4. Enter the code using the Number Buttons.
After your code is entered, the INDICATOR LIGHT will
turn off. If the code is not valid, the INDICATOR LIGHT
will blink. Check the code list and repeat process.
5. Aim the remote at your DVD System and press the
ON•OFF button. Your DVD System should turn off.
6. If the DVD System responds, no further
programming is required.
Note: If your DVD does not respond, try all the codes for your brand. If the
codes do not work, or your brand is not listed, try the Code Search method
on page 17.
7. Enter your code here for easy reference.
DVD Codes
JVC......................................................................161
Magnavox..........................................................162
Mitsubishi..........................................................163
Philips ................................................................162
Pioneer ..............................................................165
ProScan ..............................................................160
Sony....................................................................166
RCA ....................................................................160
Toshiba ..............................................................167
9
Page 10
INDICATOR
LIGHT
CODE
SEARCH
(BLINK)
DVD
1
2
3
4
5
6
7
8
9
(OFF)
0
ON OFF
DVD CODE
Hide quick links:
Advertisement
Table of Contents
