Programming With Code Search; Retrieving Codes - RCA RCU410 User Manual

Programming With Code Search

If your TV, VCR, DVD, DBS or Cable Box does not respond after you have
tried all the codes for your brand, or if your brand is not listed, try
searching for your code by following the steps below.
1. Turn on the device you wish
to program.
2. Press and hold CODE SEARCH
until the INDICATOR LIGHT
lights, then release CODE
SEARCH.
3. Press and release the device
button for the device you are
programming (TV, VCR or
DBS•CABLE). The INDICATOR
LIGHT will blink once then
remain lit. DVD codes are
programmed under the VCR
button.
Note: For AUX, press DVD•AUX then
the device button you are
assigning to DVD•AUX.
4. Press and release ON•OFF until
your device turns off.
Important: You may have to
press ON•OFF up to 200 times.
5. When your device turns off,
press the ENTER button, the
INDICATOR LIGHT will go off.

Retrieving Codes

If you need to find the three-digit code for your TV, VCR, DBS, DVD or
Cable Box after your device is set-up using Code Search, use this procedure.
1. Press and hold CODE SEARCH
until the INDICATOR LIGHT
lights, then release CODE
SEARCH.
2. Press and release the device
button for the device's code
you are retrieving (TV, VCR or
DBS•CABLE). The INDICATOR
LIGHT will blink once then
remain lit.
Note: For AUX, press DVD•AUX
then the device button for the
code you are retrieving.
3. Press and release CODE
SEARCH. The INDICATOR
LIGHT will turn off.
4. Starting with 0 on the keypad,
press the number buttons in
order (0-9) until the
INDICATOR LIGHT blinks.
5. The number which causes the
INDICATOR LIGHT to blink is
the first digit of your code.
6. Repeat step 4 until you have
retrieved all three numbers in
the code.
11
CODE
SEARCH
VCR
DVD•AUX
(BLINK)
ON OFF
CODE
SEARCH
VCR
DVD•AUX
(BLINK)
CODE
SEARCH
...
INDICATOR
LIGHT
TV
DBS•CABLE
(OFF)
INDICATOR
LIGHT
TV
DBS•CABLE
(OFF)
(BLINK)