Table of Contents
Advertisement
Controlling Audio
When Speaker network is set to 3-way:
[FREQ] (High Pass)
■
High Pass Filter adjustment.
[HPF FREQ], [LPF FREQ] (Band Pass)
■
Band Pass Filter adjustment. (When Mid
Range Speaker is selected on the Speaker
Select screen)
[FREQ] (Low Pass)
■
Low Pass Filter adjustment. (When Woofer is
selected on the Speaker Select screen)
*
1
2
■
[Slope]*
Set a crossover slope.
■
[Gain]
Set the gain of each speaker.
[Phase Inversion]
■
Set the phase of tweeter, mid range, and
woofer output.
Check [Phase Inversion] to shift the phase
180 degrees.
*
1
Only when "LPF FREQ"/"HPF FREQ" (Band
Pass) is set to a mode other than "Through"
in [Xʼover].
*
Only when "FREQ" (Low Pass) is set to a
2
mode other than "Through" in [Xʼover].
NOTE
• For how to switch to the 3-way speaker system,
see 3-way speaker system setup (P.63).
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
66
Controlling General Audio
1
Press the [FNC] button.
h Popup menu appears.
h
2
Touch [
].
h HOME screen appears.
h
3
Touch [
].
h SETUP screen appears.
h
4
Touch [Audio].
h Audio screen appears.
h
5
Touch [Fader / Balance].
6
Set each parameter as follows.
■
[Fader], [Balance]
Adjust the volume balance around the
touched area.
[C] and [D] adjust the right and left volume
balance.
[R] and [S] adjust the front and rear volume
balance.
■
[Center]
Clear the adjustment.
NOTE
• When the 3-way speaker system is selected,
"Fader" adjustment is disabled.
Advertisement
Table of Contents
