Table of Contents
Advertisement
[Location] (Only for Front, Rear)
■
Select the speaker position you have
installed.
[Tweeter] (Only for Front)
■
You can set up the tweeter when you are
selecting front speakers.
None, Small, Medium, Large
■
[Xʼover]
Display the speaker crossover setup screen.
You can adjust the crossover frequency that
was set automatically when you selected the
speaker type.
For details, see Crossover network setup
(P.65).
When Speaker network is set to 3-way:
1
NOTE
• For how to switch to the 3-way speaker system,
see 3-way speaker system setup (P.63).
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
• Select "None" if you have no speakers.
Ñ
Crossover network setup
You can set the crossover frequency of
speakers.
1
Touch [Xʼover].
2
Touch the speaker to set up.
2
3
Set each parameter as follows.
[HPF FREQ]
■
High Pass Filter adjustment. (When Front or
Rear is selected on the Speaker Select screen)
[LPF FREQ]
■
Low Pass Filter adjustment. (When
Subwoofer is selected on the Speaker Select
screen)
1
■
[Slope]*
Set a crossover slope.
■
[Gain]
Adjust the gain of the front speaker, rear
speaker, or subwoofer.
[TW Gain] *
2
■
Adjust the tweeter level. (When Front is
selected on the Speaker Select screen)
[Phase Inversion]*
■
Set the phase of subwoofer output.
Check [Phase Inversion] to shift the phase
180 degrees. (When Subwoofer is selected
on the Speaker Select screen)
*
Only when "LPF FREQ"/"HPF FREQ" is set to
1
a mode other than "Through" in [Xʼover].
*
Only when "Tweeter" is set to "Small",
2
"Medium", "Large" in [Speaker Setup].
*
3
Only when "Subwoofer" is set to a mode
other than "None" in [Speaker Setup].
Controlling Audio
3
English
65
Advertisement
Table of Contents
