Maintenance - Husqvarna ST 224 Operator's Manual

Hide thumbs Also See for ST 224:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
1. Start the engine and let it operate for some
minutes. Stop the engine and wait for all moving
parts to stop.
2. Remove snow and loose ice from the product.
3. Remove snow and loose ice from the base of the
chute.
4. Turn the chute deflector to the left direction and
to the right direction to remove ice and water.
5. Remove the key or flip switch to the "OFF"
position (if equipped).
6. If the product does not have an electric starter,
pull the starter rope handle several times to
remove ice and water.
7. If the product has an electric starter, connect the
product to power and push the start button once
to remove ice and water.
To get a good result
Always run the engine at full throttle or near full
throttle.
Introduction
When the product is in use, bolts can loosen and
components can become worn. This can cause
Maintenance schedule

Maintenance

Make sure that nuts
and screws are
tightened
Do a check of the
engine oil level
1
Replace oil
Make sure there are
no fuel or oil leaks
Remove clogging,
foreign objects in
auger
Inspect the tire
2
pressure
Inspect and change
3
the spark plug
Note: It is not necessary to add grease or to do other
maintenance to the gearbox.
1
Replace the oil after the first 20 h, 50 h, 100 h and then every 100 h.
2
See Technical data for correct tire pressure.
3
Check and clean spark plug before use each year.
14
Maintenance
Daily
20 hours
X
X
X
X
Always adapt the speed of the product to the
snow situation and adjust the speed with the
drive speed control lever. Make sure that the
product throws snow evenly.
It is easier and more efficient to remove snow
immediately after it falls.
Always throw snow downwind whenever
possible.
On flat surfaces, like asphalt roads, raise the skid
plates up to 5-6 mm (0.2-0.25 in) off the ground.
The scraper bar is reversible. When it becomes
worn almost to the edge of the housing, reverse
it. Replace the scraper bar if it is damaged, or if
both sides are worn.
Do not dispatch the chute deflector if it is
clogged.
If the product does not move forward due to
unforeseen circumstances, release the drive
engagement immediately or move the ON/OFF
key to the "OFF" position.
malfunction like incorrect tolerance clearance,
increased oil consumption, or misalignment of
various components. Do regular maintenance on the
product to prevent malfunction.
50 hours
X
X
X
100 hours
X
X
1481 - 004 - 14.04.2021

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

St 227St 230

Table of Contents