Remote Control Interface - Siemens VersiCharge SG VCSG30GRYUW Installation And Operation Manual

Setting
Label
Current (A)
Power (kW)
Circuit Requirements

Circuit must be sized for the max ampere requirement. Do not de-rate breakers or
conductors based on amperage adjustment

3.6 Remote Control Interface

The Siemens VersiCharge has a Remote Control Interface that allows charging to be
controlled by an external device. This function is for wired control, and is separate from
the remote control system associated with phone and web applications.
WARNING!
higher voltage on this interface can cause damage to unit, preventing it from functioning
properly. Do not hook up 120/240 V to these connections.

Control Switch input is a dry contact input from
an external source.

Status Output indicates the charging status of
the VersiCharge.

The Remote Control Interface is located inside
the unit so to connect a device, the unit has to
be opened by taking the following steps:
o Set the circuit breaker for this circuit to the
'OFF' position
19
0 1
MIN 25%
6 7.5
1.44 1.8
Remote Control Interface should be low voltage control wiring. Installing
©
2015 Siemens Industry, Inc.
2 3
50% 75%
15 22.5
3.6 5.4.
4
MAX
30
7.2
R814365 Rev05