Devolo Magic2 Manual page 31

Lan triple

Hide thumbs Also See for Magic2:

Table of Contents

31 Configuration

To do so, enter the desired new password twice.

Now the web interface is protected against un-

authorised access with your custom password!

Identify Device

The devolo Magic adapter can be located using the

Identify device function. Click Identify to make

the white LED for the corresponding adapter flash

for 2 minutes to make it easier to identify by sight.

LED

Enable the LED disabled option if the LEDs on the

devolo Magic adapter are intended to be switched

off for normal operation. An error status is indica-

ted by corresponding flashing behaviour regard-

devolo Magic 2 LAN triple

less of this setting (see Chapter 2.3.1 Reading the

indicator light).

Powersaving

If Powersave mode has been enabled, the

devolo Magic 2 LAN triple switches to Powersave

mode automatically whenever reduced data trans-

mission over ethernet is detected.

The latency (time for transmitting a data

packet) may be negatively affected.

Powersave

mode

devolo Magic 2 LAN triple factory default settings.

disabled

the

Table of Contents