Figure 9 J5 - St-Link Swd Connection And Pinout; Figure 10 Stm32Cubeide Debugger Configuration - MACH SYSTEMS MACH-ETH User Manual

An ST-LINK v2 or v3 debugger and a TagConnect TC2030-NL header [4] is needed.
p/n: TC2030-CTX-NL-STDC14
Please make sure SWD Interface is selected in STM32CubeIDE project configuration as shown in
Figure 11.
MACH SYSTEMS s.r.o.
Figure 10 J5 - ST-LINK SWD Connection and Pinout
Figure 11 STM32CubeIDE Debugger Configuration
www.machsystems.cz
info@machsystems.cz
MACH ETH - User Manual
Page 16 of 20