MACH SYSTEMS MACH-ETH User Manual page 13

•
Short the boot pads together (a pair of tweezers can be used)
•
Connect the power supply - either USB or external
•
The device will enter the system bootloader
•
Release the boot pads
•
Firmware can be flashed as described in 5.6
•
Close the enclosure
The steps for Ethernet bootloader:
•
Disconnect the USB and the external power supply
•
Open the enclosure
•
Connect the power supply - either USB or external
•
Connect the Ethernet cable
•
Short the eth boot pads together (a pair of tweezers can be used)
•
The device will enter the Ethernet bootloader
•
Release the boot pads
•
Firmware can be flashed as described in 5.4
•
Close the enclosure
C. With internet browser
•
Open Chrome internet browser
•
Type IP address (default IP address is 192.168.1.100) of the device in the
address bar
•
At the bottom of the page, click on the button Go to USB bootloader to enter
the system bootloader
o Window with the short message is shown
o Firmware can be flashed as described in 5.6
•
To enter Ethernet bootloader, click on Go to Ethernet bootloader
o Window with short message is shown
o Firmware can be flashed as described in 5.4
D. Send protocol message
MACH SYSTEMS s.r.o.
www.machsystems.cz
info@machsystems.cz
MACH ETH - User Manual
Page 13 of 20