Installing SD card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the SD card reader and provides a visual representation of the installation procedure.
Steps
1. Align and place the SD card reader with the FPC into its slot on the computer chassis.
2. Replace the (M2x2) screw to secure the SD card reader to the computer chassis.
3. Connect the LED board FFC and SD card reader FPC to the SD card reader.
Next steps
1. Install the
inner
frame.
2. Install the battery.
3. Install the
secondary solid-state
4. Install the
primary solid-state
5. Install the
base
cover.
6. Follow the procedure in
SD card reader FPC
Removing SD card reader FPC
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
primary solid-state
66
Removing and installing components
drive.
drive.
after working inside your
before working inside your
drive.
computer.
computer.