Fitting The Impact Guard (325P5); Assembly Of The Saw Attachment (325P5) - Husqvarna 325P5X Series Operator's Manual
Hide thumbs
Also See for 325P5X Series:
- Operator's manual (32 pages) ,
- Operator's manual (32 pages) ,
- Operator's manual (28 pages)
Table of Contents
Advertisement
•
Tighten the knob.
Dismantling:
Undo the knob (at least three turns).
•
Push the knob towards the coupling.
•
Carefully twist the upper shaft to unlock it.
•
Hold both parts of the shaft and pull the upper shaft out of
the coupling.
Fitting the impact guard (325P5)
If the machine has a protective guard bolted under the engine
this should be removed before the impact guard is
assembled.
Fit the guard using the three screws and washers. Fit the two
short screws in hole A. Tighten the screws to a torque of 4
Nm. After the machine has been in use for around 20 hours,
re-tighten the screws to 4 Nm.
ASSEMBLY
Assembly of the saw attachment
(325P5)
Assembly
•
Make sure the knob is loose.
•
Align the cut-out in the upper shaft with the coupling's lock
plate on the lower shaft. The parts then lock together.
•
Tighten the knob.
Dismantling
•
Undo the knob (at least three turns).
•
Push the knob towards the coupling.
•
Carefully twist the upper shaft to unlock it.
•
Hold both parts of the shaft and pull the upper shaft out of
the coupling.
– 15
English
Advertisement
Table of Contents
