Inspection - Description Of The Machine; Check Before Starting; Fitting The Disc - Husqvarna TS 73 R Owner's Manual

3

Inspection - Description of the machine

• On receiving the machine check its condition.
• Always keep it perfectly clean
• Check the supply cable and the extension lead
periodically
• Always keep alert when working
• Check that the parts are properly fixed (no
abnormal vibration) and that it is correctly
assembled.
1
FIG.
1
Chassis
2
Leg
3
Leg locking knob
4
Water pump
5
locking Clip
6
90° to 45° locking knob
7
19 mm spanner
8
Drain plug
9
Motor
10
Lack of voltage switch
11
Operating handle
12
Disc casing
13
Rail
14
Plate
15
Plate stops
16
Head carriage
17
Manufacturer's plate
18
Cutting plate
19
Plate side extension
20
Tank
4 Transport
• Lock the head on the rear part of the machine
(A) - [
SEE FIG.
using clip
• Loosen the two flywheels
swivel them, then retighten the flywheels
[ 3].
SEE FIG.
• Repeat the same procedure for the back legs.
• To reinstall the machine on its legs, carry out the
same procedure in reverse.
For these different operations
always disconnect the machine
2]
(B) of the front legs,
(B) -
5

Check before starting

Please read the instructions for use
prior to operating the machine for
the first time.
Motor off.
The working
completely cleared, well lit and all
safety hazards removed (no water
or dangerous objects in the vicinity)
The operator
protective clothing appropriate
to the work he is doing. We
recommend that this includes
both eye and ear protection
The use of ear protection is
mandatory.
Any persons not involved in the
work should leave the working area
Use only blades marked with a
maximum operating speed greater
than blade shaft speed
6

Fitting the disc

Disconnect the machine by unplugging
the supply cable.
• Release the two knobs
remove them and then remove the guard.
• Unscrew the disk clamping nut
using a 19 mm spanner.
The disc locking nut has a left-hand
thread.
• Remove the clamping plate
Take care about the direction of
rotation which is shown by an arrow
on one of the faces.
Make sure the contact faces of
flanges, of blade and the axle are
clean.
• Check the disk position on the centring plate
- [ 6]
SEE FIG.
• Refit the clamping plate
(D).
• Replace the guard, tighten the knobs
area must be
must wear
(C) - [ 4],
SEE FIG.
(D)- [ 5]
SEE FIG.
(E) and fit the disk.
(F)
(E) and tighten the nut
(C).
9