Advertisement
5.1.
ASSEMBLY
5.1.1.
Connect air supply to sander, press the control valve lever and check that the sander is working correctly.
5.1.2.
The air flow may be regulated by adjusting the regulator valve in the back of the handle.
5.2.
OPERATING
5.2.1.
Screw the sanding disk carrier onto the shaft and tighten with the spanners provided.
5.2.2.
Connect a mini sanding disc by screwing it into the centre of the carrier.
5.2.3.
Connect the tool to the air supply, section 4.
5.2.4.
To operate the sander, squeeze the trigger.
NOTE: The air regulator/speed control may be used as a means of throttle control.
DO NOT go from coarse to fine in one step as it may be difficult to remove swirl marks left by the coarse grit.
8
DO NOT apply excessive pressure, let the sander do the work for you. Start the sander and bring the sanding disc to the work surface
8
evenly and slowly. Move the sander back and forth in overlapping areas.
Remove the sanding disc from the work surface before stopping the sander. Regularly check the sanding disc for wear, always change
9
if cracked or damaged.
DO NOT allow sander to run in "idle rotation" for an extended period of time, as this will reduce bearing life.
8
6. MAINTENANCE
WARNING! Disconnect sander from air supply before changing accessories, servicing or performing maintenance. Replace or
‰
repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
6.1.
If the air supply does not have an oiler lubricate the air sander daily with a few drops of good grade air tool oil such as Sealey
ATO/1000, dripped into the air inlet before use.
6.2.
Clean the sander after use and change pads when required.
6.3.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or type of hose connectors. To remedy check
the air supply and follow instructions in Section 4.
b) Grit or gum deposits in the sander may also reduce performance. If your model has an air strainer (located in the area of the
air inlet), remove the strainer and clean it. Flush the sander out with gum solvent oil or an equal mixture of SAE No 10 oil
and kerosene. Allow to dry before use. If problems continue, contact your local Sealey service agent.
6.4.
For a full service contact your local Sealey service agent.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 36 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
SA1003 Issue 3 (ALL) 18/05/23
REGISTER YOUR
PURCHASE HERE
Advertisement
