Sealey SA17/S.V2 Instructions

INSTRUCTIONS FOR :
180mm AIR ANGLE POLISHER
SA17/S.V2
MODEL:
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
! WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to
when using this equipment.
! WARNING! Disconnect from air supply before changing accessories or servicing.
" Maintain the polisher in good condition (use an authorised service agent).
" Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will
invalidate the warranty.
" Use in a suitable, clean and tidy work area, free from unrelated materials. Ensure that there is adequate lighting.
" Before each use check pad for condition. If worn or damaged replace immediately.
! WARNING! Always wear approved eye or face and hand protection when operating the polisher.
" Use face, dust, or respiratory protection in accordance with COSHH regulations.
" Noise level may exceed 85dB - wear safety ear defenders.
" Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain and/or tie back long hair.
" Wear appropriate protective clothing and keep hands and body clear
of pad.
" Maintain correct balance and footing. Ensure that the floor is not
slippery and wear non-slip shoes.
" Keep children and unauthorised persons away from the work area.
" Ensure workpiece is secure before operating the polisher. Never hold a
workpiece by hand.
" Avoid unintentional starting.
! WARNING! Ensure that correct air pressure is maintained
and not exceeded. Recommended pressure is 90psi.
" Keep air hose away from heat, oil and sharp edges.
" Check air hose for wear before each use and ensure
that all connections are secure.
" Prolonged exposure to vibration from this polisher may pose a health risk. It is the owner's
responsibility to correctly assess the potential hazard and issue guidelines for safe periods of
use and offer suitable protective equipment.
# DO NOT use a polishing pad which has a speed rating less than the speed rating of the
polisher.
# DO NOT use the polisher for a task it is not designed to perform.
# DO NOT operate polisher if any parts are damaged or missing as this may cause failure and/or
personal injury.
# DO NOT carry the polisher by the hose, or yank the hose from the air supply.
# DO NOT force, or apply heavy pressure to the polisher, let the polisher do the work.
# DO NOT operate polisher when you are tired or under the influence of alcohol, drugs or intoxicating medication.
# DO NOT carry the polisher with your finger on the power lever.
# DO NOT direct air from the air hose at yourself or others.
" When not in use, disconnect from the air supply and store in a safe, dry, childproof location.
SA17/S.V2 - 1 -040907