RCA DRC510N User Manual page 9

Connection: DVD + TV + VCR
1.
Connect the audio cables to the AUDIO OUT L (left – white) and R (right – red) jacks on
the back of your DVD player, and to the corresponding Audio Input jacks on your TV
(sometimes labeled AUDIO IN L and R).
2.
Connect the video cable.
2a. Basic video connection – Connect the video cable (yellow) to the VIDEO OUT jack on
the back of your DVD player, and to the Video Input jack on your TV (sometimes
labeled VIDEO IN).
2b. S-Video (optional) – If your TV has an S-Video jack, connect the S-Video cable (not
provided) to the S-VIDEO OUT jack on the back of your DVD player and to the
S-VIDEO jack on your TV.
2c. If your TV has component video jacks (Y, Pb, Pr), use video-grade cables (not provided)
to connect the TV to the DVD player's COMPONENT VIDEO OUT jacks — Y to Y, Pb
to Pb, R to R. It is essential to match the color coded connectors with a compatible TV.
Note: If your TV or monitor has progressive scanning capability, you need to turn the VIDEO SELECTION switch to
the PROGRESSIVE SCAN ONLY position.
3. Connect the antenna or cable to the Antenna Input jack on the VCR (sometimes labeled IN
FROM ANTENNA).
Note: Connecting a VCR is optional. It is only shown in this diagram because most households have a VCR
connected to the TV.
4.
Connect a coaxial cable to the Antenna Output jack on the VCR (OUT TO TV) and to the
Antenna Input jack (CABLE/ANTENNA) on the TV.
5.
Insert the power cord into an AC outlet.
Note: If your TV doesn't have Audio and Video Input Jacks and only has an RF jack, you need
to connect an RF modulator (not provided). For information, go to page 40.
– OR –
– OR –
Graphics throughout this User's Guide are for representation only.
Connections and Setup
7
Go to page 8