Table of Contents
Advertisement
Preparation of Use
ª Removing the transit screw
Unscrew the transit screw with a Phillips head screw-
driver by rotating counterclockwise until the screw is
completely removed.
ª Connecting speakers
Connect each speaker plug to the speaker terminal.
Use speakers with impedance of 4 ohms or more, since
low impedance speakers may damage the unit.
ª Connecting the AC power cord
After connecting the speakers, insert the power plug
into the wall outlet firmly.
The STANDBY indicator on the panel will light.
ª Battery installation for memory backup
Set a new "006P" 9V battery to the terminal inside the
battery compartment on the rear panel. The battery will
keep the preset radio stations in memory.
... Replace the battery with new one approximately
every one year. When replaced, preset stations may
be erased from the memory. In this case, memorize
the station again.
Memory Backup Battery
Compartment
Transit Screw
This equipment draws nominal nonoperating power
from the AC outlet with its POWER switch in the OFF
position.
Obs! nätströmställaren skiljer ej fela apparaten från
nätet.
ª Battery installation for Remote
1. Remove the battery compartment cover.
2. Insert three "AAA" (R03, UM-4) dry batteries.
3. Close the cover until it clicks.
ª
If the distance required between the remote control unit
and main unit decreases, the batteries are exhausted. In
this case replace the batteries with new ones.
ª
... Be sure to insert the batteries with correct positive
... Use batteries of the same type. Never use different
... Rechargeable and non-rechargeable batteries can be
... When the remote control unit is not to be used for a
... Do not heat or disassemble batteries and never
To AC Outlet
Speaker Plugs
- 5 -
Control Unit
Make sure that the batteries are inserted with their
positive ± and negative — poles positioned correctly.
Battery Replacement
Precautions concerning batteries
"±" and negative "—" polarities.
types of batteries together.
used. Refer to the precautions on their labels.
long time (more than a month), remove the batteries
from the remote control unit to prevent them from
leaking. If they leak, wipe away the liquid inside the
battery compartment and replace the batteries with
new ones.
dispose of old batteries by throwing them in a fire.
Advertisement
Table of Contents
