NEC NP-NC1000C User Manual page 26

3. Projection of Images (Basic Operation)
6
Press the LAMP ON/OFF button on the control panel for three seconds or longer.
The lamp is turned on and the screen glows light about 15 seconds later. The LAMP ON/OFF button indicator blinks
in cycles of 2 (and changes to steady green light 90 seconds later).
The douser is closed until the screen glows light (the DOUSER button indicator lights green). When the douser is
open, the DOUSER button indicator turns off.
• While your projector is on, be sure to have the lens cap removed from the lens.
NOTE
Otherwise, the lens cap may get deformed due to a heat buildup.
• In the following instances, the power to your projector cannot be turned on even if you press the POWER
button.
- When the inside temperature is abnormally high. The protective function prevents power from turning on.
Wait some time (until the projector inside cools down) and then turn on the power.
- When the STATUS indicator is blinking in red without the lamp lighting up after power-on. Your projector may
be in trouble. Check the error display on the LCD screen and contact your dealer/distributor for
instructions.
• Note that the image may sometimes flicker until the lamp has stabilized (5 to 10 minutes) after power-on. This
is due to the characteristics of the lamp and is not trouble of your projector.
26