Pride PURSUIT Series Owner's Manual page 24

Table of Contents

Advertisement

WARN I N G! Whe n your sc oot e r is in fre e w he e l m ode , t he bra k ing syst e m is dise nga ge d.
Dise nga ge t he drive m ot ors only on a le ve l surfa c e .
Ensure t he k e y is re m ove d from t he k e y sw it c h.
St a nd t o t he side of t he sc oot e r t o e nga ge or dise nga ge fre e w he e l m ode . N e ve r sit
on a sc oot e r t o do t his.
Aft e r you ha ve finishe d pushing your sc oot e r, a lw a ys re t urn it t o t he drive m ode t o
loc k t he bra k e s.
NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward) while the key is in
the "on" position, the scooter will not run until the manual freewheel lever is pushed backward and the
key is turned to the "off" position, then back to the "on" position.
Main Circuit Breaker (Reset Button)
When the voltage in the batteries becomes low or your scooter is heavily strained because of excessive
loads, the main circuit breaker may trip to protect the motor and electronics from damage. When the
breaker trips, the entire electrical system shuts down. See figure 8.
The reset button pops out when the breaker trips.
Allow a minute or so for the electronics to "rest."
Push in the reset button to reset the breaker.
If the breaker trips frequently, you may need to charge the batteries more often or have your authorized
Pride Provider perform a load test on the batteries.
If the main circuit breaker trips repeatedly, see your authorized Pride Provider for service.
SECURING THE SCOOTER
Always secure the scooter in a forward-facing position in the vehicle. Attach the four tie-down straps to
the designated securement points. See figures 9 and 9A. Tighten the straps to sufficiently remove all
slack. Never attach tie-downs to adjustable, moving, or removable parts of the scooter such as armrests,
shrouds, and wheels. These items should be removed. Position the anchor points for the rear tie-down
straps directly behind the rear securement points on the scooter. The front tie-down straps should anchor
to floor points that are spaced wider than the scooter to provide increased lateral stability.
WARN I N G! Ensure sc oot e rs a re prope rly se c ure d t o t he m ot or ve hic le during t ra nsport .
Sc oot e rs t ha t a re not prope rly se c ure d c a n be c om e a ha za rd t o t he use r a nd t o ot he r
ve hic le pa sse nge rs in t he e ve nt of a c ra sh, sudde n st opping, or sw e rving, a s t he sc oot e r
c ould t ip or slide out of pla c e .
FRONT SECUREMENT POINTS
Figure 9. Rear Section
24
I I I . Y O U R S C O O T E R
www.pridemobility.com
REAR SECUREMENT POINTS
Figure 9A. Rear Section
Pursuit

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents