Bissell POWERLIFTER 2259 Series User Manual page 8

Clean the Pre-Motor Filter
WARNING
To reduce the risk of electric shock, turn power switch o and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
WARNING
Do not operate vacuum with damp or wet fi lters or without all fi lters in place.
1
Press the tank release button and pull
out to remove dirt tank.
3
Allow filter to air dry completely before
placing back into the tank lid. The carbon
filter should be on top of the foam filter.
Maintain the TurboBrush Tool
1
2
Align
Slot
Remove brush roll,
Twist gray collar
belt, and paddle
counter clockwise,
wheel. Inspect
until slot appears,
for damages and
then separate
replace if necessary.
faceplate.
8
www.BISSELL.ca
2
Remove carbon and foam filter from lid.
Hand wash in warm water and rinse well;
mild detergent may be used if desired.
4
click
Return tank back
on vacuum and
press firmly until
you hear "click".
3
Paddle Wheel
Clip
Paddle Wheel End
To reassemble, align two clips on each
end of paddle wheel with belt on and
pop back into place.
Place brush roll with belt back in.
Faceplate will not close properly if all
parts are not aligned correctly.
Roller
Belt