Table of Contents
Advertisement
Normal Steering Sensitivity (0% exponential)
In this illustration, the steering servo's travel (and with it, the
steering motion of the model's front wheels) corresponds precisely
with the steering wheel. The ranges are exaggerated for illustrative
purposes.
Decreased Steering Sensitivity (Negative Exponential)
By turning the Multi-Function knob clockwise, the steering
sensitivity of the model will be decreased. Note that a relatively
large amount of steering wheel travel results in a smaller amount of
servo travel. The farther you turn the knob, the more pronounced
the effect becomes. Decreased steering sensitivity may be helpful
when driving on low-traction surfaces, when driving at high speed,
or on tracks that favor sweeping turns where gentle steering inputs
are required.The ranges are exaggerated for illustrative purposes.
Effective Turning
Turning Range
Range on Model
at Transmitter
Experiment! Try varying degrees of exponential. It's easy to go back
to "zero" if you don't like the effect. There's no wrong way to adjust
exponential. Any setting that makes you more comfortable with
your model's handling is the "right setting."
TRAXXAS TQ
RADIO & VELINEON POWER SYSTEM
i
SETTING UP THE ANTENNA
The receiver antenna has been set up
and installed from the factory. The
antenna is secured by a 3x4mm set
screw. To remove the antenna tube,
simply remove the set screw with the
included 1.5mm wrench.
When reinstalling the antenna,
first slide the antenna wire into the
bottom of the antenna tube until
the white tip of the antenna is at
the top of the tube under the black
cap. Next insert the antenna tube
into the mount while making sure
that antenna wire is in the slot in the antenna mount, then install
the set screw next to the antenna tube. Use the supplied 1.5mm
wrench to tighten the screw just until the antenna tube is securely
in place. Do not over tighten. Do not bend or kink the antenna
wire! See the sidebar for more information. Do not shorten the
antenna tube.
Antenna
Tip
Antenna
Tube
Antenna
Mount
Correct
STAMPEDE 4x4 VXL • 15
To prevent loss of radio
range do not kink or cut the
black wire, do not bend or
cut the metal tip, and do not
bend or cut the white wire at
the end of the metal tip.
No
No
No
Advertisement
Table of Contents
