Table of Contents
Advertisement
STEP 3 Adjust the levelling feet
STEP 4 Initial settings
By completing the following steps, the refrigerator should be fully functioning.
1. Plug the power cord into the wall socket to turn the refrigerator on.
2. Open the door, and check if the interior light lights up.
3. Set the temperature to the coldest, and wait for about an hour.
4. Remove the 4 shipping caps from the shelf, which are attached for safe transportation.
5. Wait until the refrigerator reaches the set temperature.
Now the refrigerator is ready for use.
STEP 5 Final check
When installation is complete, confirm that:
• The refrigerator is plugged into an electrical outlet and grounded properly.
• The refrigerator is installed on a flat, level surface with a reasonable clearance from the
wall or the cabinet.
• The refrigerator is level and is sitting firmly on the floor.
• The door opens and closes freely, and the interior light turns on automatically when
you open the door.
OneDoor_RR1500K_DA68-03111C-03_EN.indd 21
Level the refrigerator by manually
adjusting the levelling feet.
Turn the levelling feet clockwise to lower
the position, or turn counter clockwise to
raise.
For safety reasons, adjust the front side a
little higher than the rear side.
NOTE
This model does not allow for adjusting the
front right foot that is fixed. Use the front
left foot for levelling.
English
21
2016-11-10
5:28:50
Advertisement
Table of Contents
