NAVTELECOM SIGNAL S-2651 Operation Manual page 7

FLEX 3.0 protocol support
Number of servers (IP addresses) for synchronous receiving of telemetric
data
Sending telemetry data to the server repeatedly by SMS or GPRS request
for the period
Output of user and debug logs from GSM modem, GPS receiver and
interfaces
Data transferring in TCP and UDP
The number of subscribers for SMS-alert
EcoDriving function
Vehicle evacuation tracking
Crush event determination in accordance with acceleration thresholds or
Addiction Severity Index (ASI)
Formation and sending accident profile file to the server
Immobilizer function using driver identification system by Proximity cards
and 1-Wire interface
Programmable power-saving mode with the ability to disable
GLONASS/GPS and GSM-modules
Device operation on the timer or by the calendar
Security mode
GSM-signal jammer detector
GNSS jammer detector
SMS sending according to speeding event
Determination of engine operation and engine hours calculation by the
voltage in the vehicle electrical system
Sensors selection for engine hours calculation
Tachometer function with engine speed calculation
Providing LBS information from three nearest towers cell towers
Data encryption according to the AES128 standard in data transfer
Real mileage measurement algorithm with the terrain features
Sensors selection for coordinate averaging
Configuration of data averaging over all inputs for fuel level sensors
Ability to stop operation of fuel sensors under specified conditions
(lowering the supply voltage below the threshold, turning off the ignition,
turning off the engine)
Configuration of outputs operation (continuous, single, periodic)
Digital fuel level sensors connection by RS-232 interface
The maximum number of connected digital fuel level sensors by RS-485
interface
Ability to calibrate LLS fuel level sensors in the device
Synchronic operation of fuel level sensors (LLS) and tachographs (Shtrih,
Mercuriy, Atol) on RS-485
MODBUS RTU protocol support
Operation with RFID-tags readers "Escort" ("Radius"), "ADM20", "Mielta"
and LLS-compatible
NMEA string output from the navigation module by RS-485 interface
CAN interface with J1939 standard
Support of CAN protocols other than J1939 by decoding files
Parsing CAN parameters by user settings
Operation with CAN buses of J1708 standard via RS-485 interface
CAN-LOG and CAN-FMS adapters support
DTA-CAN CAN adapter support
Connection a Bluetooth headset for two-way communication with the driver
Functionality
yes
3
yes
yes
yes
5
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
16
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes
yes